Make Your Own Golf Clubs

For the amateur golfer, to make your own golf clubs or just that one special club can be a lot of fun, and it could help your game.

You may ask why you would ever want to build your own golf clubs.Well, the big reason is that when you buy clubs off the shelf, you are stuck with the sizes and fits that are in stock – limited only.  There may be one size for men; another for the women; and another for children who need junior golf clubs. At 6 ft 2 in, for me buying off the rack can cause my golf game to suffer and cause some annoying back aches because if the clubs are too short. By learning to make your own golf clubs you can help your body and save some cash at the same time.

There really isn’t much needed to make one’s own golf clubs.You just need a head, shaft, grip and some other materials to hold it all together.Browsing through the net will give you many great options to buying your components and make clubs that match your game.

Club heads — iron and wood heads are available anywhere. You can buy club heads that resemble popular brands or designs unique to the manufacturer you buy from. Each vendor offers their own line of clubs.

Shafts – you can buy the same shafts that the name brand golf club companies use.

Grips – there are a variety of sizes and types of grips.You can find them in different prices and even get the same ones the pros use..

Ferules — That’s the little plastic piece that goes on the end of the shaft above the club head on some clubs. These are purely decorative except on graphite shafts, where they are needed to absorb some of the stresses where the shaft joins the club head.

The beauty of finding the components to make your own club is the fact that you can actually mix and match the components to match your game.

What You Need To Make Your Own Golf Clubs

Grip tape – two sided tape is needed

Grip tape solvent – very cheap and you can recycle the excess

Epoxy – you will needs an epoxy with a drying time of 2-3 hours

Pipe cutter for cutting steel shafts, a plumbing cutter will work fine

For graphite shaft use a hack saw

Grip cutting knife – one with a hooked blade works nicely

Sandpaper for roughing up shaft tips to epoxy them

Shaft clamp – a thick piece of rubber in a vise works well

Making a golf club consists of measuring and cutting the shaft to length, abrading the tip to make sure the bond to the head is as good as possible. You then push the ferrule over the thin end of the shaft and glue the head to the shaft with an epoxy. Waiting for the epoxy to dry is the worst part of the job… You want to take your new golf club to the course and try it out. Once the epoxy has set, you wrap the butt end of the shaft with grip tape (double-sided sticky tape), wet it using one of a wide range of solvents, slide the grip over it and let dry. Once that is done, you can now clean your new golf club – polish the ferrule and end up with something better than you buy at the store.

So get to your computer, find some great websites and order your components. In no time, you will be able to create your own golf clubs. So, go and have some fun.

Those who have played golf knows that it’s addictive.  If you decide to make your own golf clubs
you might find that addictive as well.